1 The free stroke of the clutch should be kept within the specified range, and pay attention to checking and adjusting regularly. 2 The three separation levers of the clutch are consistent with the clearance of the release bearing and meet the specified requirements. 3 The driven plate should be flat. If warpage occurs, it should be repaired in time. 4 Tractor equipped with a single cylinder engine. Reduce the throttle before shifting and wait until the speed is significantly reduced before shifting. 5 tractor equipped with multi-cylinder engine, shift should be used when the two-legged clutch method, that is to reduce the throttle first, after the speed is reduced, step on the clutch pedal, gear shift to neutral gear; relax the clutch pedal, increase the throttle, increase speed; Lower clutch pedal, shift the shift lever into low gear. At this time, the gear speeds of the top and the bottom of the passive gears are relatively close to each other, and they are easy to mesh. Guangdong Jia Mei Biological Technology Co.Ltd , https://www.jaymeimask.com
The new driver is in the tractor driving operation. The gear shifting phenomenon often occurs. Not only gives a harsh noise, but also greatly intensified gear wear and even broke the gear. To overcome gear shifts, the following points should be noted: