The year of planting walnut trees was mainly to ensure the survival and to accelerate the growth of seedlings. The following management must be carried out. 1. After planting till the end of May, it is necessary to water and resist drought during droughts, especially in the period of budding and leaf development; during the rainy season, drains should be drained in time to prevent the death of roots. Reasonable control of moisture is the key to determining the survival rate. 2, from the beginning of June to August ground fertilization materials, apply once a month urea, fertilizer amount 50 grams per plant per plant, after August each plant phosphorus and potassium fertilizer 100 to 150 grams. 3. When the seedlings reach 80 centimeters in length, they will be picked up (for the seedlings that have already been dried when they are planted). After germination, 3 buds with different directions and 6 to 8 centimeters apart will be selected as the main shoot culture. All other buds within 5-6 cm in the vicinity of the main branch culture buds were all wiped out so as not to affect the growth of the three main branch buds. When the buds that do not affect the growth of the main branch grow to 20-25 cm, the branches are picked up and the branches are treated with the former. The remaining three main branches grow to 40-45 centimeters and pick their hearts. After branching, one bud was selected as the extension branch, and one bud was selected as the lateral branch culture. When the lateral branch grows to 30 centimeters, pick up the heart and extend the branch to 45 to 50 centimeters. Using the method of piling with a rope, the distribution direction of the three main branches is uniform, and the branching angle is about 45 degrees. Does not affect the extension of shoots and lateral shoots of buds, according to the degree of density or erased or left: generally leave a bud 15 to 20 cm apart, to grow to 20 to 25 cm when picked up as ancillary branch culture. Some walnut varieties have strong early-maturity, and most of them have female flower buds when the seedlings are planted in the same year. They are removed timely after discovery to avoid affecting survival and tree growth.
Knitted gloves are used for common work
situations and provide basic Hand Protection.It is usually made of 100%
cotton yarn or 100% polyester yarn or TC yarn.
Depending
on different work protection requirement, It can be attached some
material on the palm of the glove. For example: dotted PVC, PVC coating,
PU coating, Nitrile coating or latex coating. It for increase the wear
resistance of gloves, oil resistance, acid and alkali resistance.
Knit Gloves,Latex Coated Glove,Latex Dipped Glove,Work Latex Gloves Greateagle Safety Products Co., Ltd. , https://www.greateaglesafety.com