Agricultural machinery operating in different environments sometimes causes disharmony of some parts. At this time, adding some lubricating oil to these parts will greatly increase the operating performance of agricultural tools. Diligently check the parts of these “oil†and can Improve machine operation and work efficiency. 1. Clutch release bearing. In the operation of agricultural machinery such as ditching, rotary tilling, and sowing, the clutch is used very frequently and it is also easy to damage and cannot be ignored. The clutch release bearing should be maintained before each quarterly operation by removing the separating claw and separating the bearing, cleaning and drying with diesel oil or kerosene, and heating in a container filled with calcium-based grease to allow the thermal grease to infiltrate into the bearing. Inside, then remove and install it. 2. Tail axle assembly. The rotating parts of the tractor's tail wheel are many parts, and the working conditions are poor. After the end of the season, the tractor should be removed for cleaning and grease lubrication. Check the seal of the oil seal and replace it if it is damaged. Do not think that the tail wheel can still rotate without having to maintain, once the bearing is stuck, the trouble of the journal can be great. 3. Sleeve shaft sleeve. Sleeve shaft bushings work in harsh environments where there is a lot of dust and moisture, and can easily wear or pull. Do not think that the boring axis can be rotated without maintenance, otherwise it will cause the journal to be worn, damaged or even scrapped. During maintenance, remove impurities such as sand grains embedded in the sleeve and add calcium-based grease to lubricate. If the sleeve wears badly, replace the new sleeve. 4. Rotary cultivator coulter shaft bearings. The 308 bearing on the right side of the ploughshare coulter shaft of the rotary cultivator of the walking tractor is lubricated with gear oil. Some operators ignore that the 207 bearing on the left side is to be lubricated with calcium-based grease. This will cause the bearing to be lubricated. The lack of oil dried up, the heat in the operation was stuck, and even the bearings ran round and the journal was severely damaged and scrapped. Therefore, the oil seal and bearing on the left side of the coulter shaft should be removed during the maintenance. After cleaning with diesel oil, add calcium-based grease. 5. Trencher limited depth wheel bearings. There are two 60204 bearings on the two ends of the deep groove wheel weldment of the hand-held tractor equipped with a disc ditch. The bearing is covered with a waterproof cover. Do not think that the depth wheel can rotate without maintenance, otherwise it will cause the axle to become stuck. Worn. Maintenance can be done after the end of each quarter, remove the lower limit deep wheel, remove the 60204 bearing clean diesel oil, and then add calcium-based grease lubrication. 6. Drill seeding clutch. 2bg and other series seed drills of the seed clutch, due to poor sealing, easy to enter the dust to dry the grease, resulting in clutch work failure. Therefore, before each season sowing operation, the clutch of the seed type should be dismantled, the internally deteriorating grease should be removed, and new calcium-based grease should be added. 7. Thresher roller bearings. Roller bearings work under conditions of high dust and humidity, and do not assume that the rollers can rotate to ignore maintenance. Failure to do so can result in early wear and even scrapping of the drum journal. Before each quarter of operation and operation, attention should be paid to inspection, grease lubrication should be added in time, and bearings that are seriously worn or damaged should be promptly replaced. Spice Novelties Co.,Limited , https://www.wholesale-adult-toys.cn