First, parking location It is best to park in the warehouse, but do not put it together with chemical fertilizers and pesticides to prevent its volatile components from corroding. If it is parked outdoors, the ventilation area with higher ground should be selected and covered with plastic cloth or other covering to prevent mechanical damage and corrosion. Second, the body pad Raise tractors with wooden piers or masonry to reduce tire loads. If you do not support the body, the tire will increase the amount of inflation 10% -20%, and should always check, often inflated, can not be lack of gas. Third, thoroughly clean Remove dirt and oil on the surface of the tractor, comprehensively inspect, adjust, and sturdy all parts and screws to avoid loosening. Fourth, put a clean oil After the tractor is deactivated, all the cooling water, diesel oil, and engine oil in the engine should be put on the net. Fifth, maintenance of parts Take the appropriate amount of dehydrating oil (the oil is heated to about 130 degrees) into the intake pipe, crankshaft, so that the oil adheres to the piston, piston rod, cylinder liner and valve. And the piston is shaken to the top dead center of compression, so as to avoid the valve springs, push rods and other parts from being compressed for a long time to lose their performance. Six, remove the injector After cleaning the injector, place it in clean diesel, loosen the adjusting screw, and plug the injector chamber with a cork. Seven, axle box oiling Take 1 kilogram of dehydrated oil, pour it into the crankcase, then shake the crankshaft several times to make the lubrication system fully filled with dewatering oil. Eight, parts oiled Apply dewatering oil to the fastening parts such as the swaying wall, high pressure oil pipe, fuel injectors, bolts, and nuts to prevent rust. Nine, do a good job of lubrication According to the overall lubrication requirements of the tractor, choose a lubricant that meets the standards for full lubrication. Tenth, packing dust Place the engine's air cleaner, exhaust duct, water tank port, tank port, etc., into the dust, and use plastic sheeting or oil-paper to bind it securely to prevent it from entering the sundries and dust. HEBEI PINGLE FLOUR MACHINERY GROUP CO., LTD , https://www.plrollermill.com