I. Preparation before stocking. 10 days before stocking was disinfected with quicklime, and the lime granules were hydrated into slurry. The whole pond was splashed with water. After sterilizing 0.15 kg of lime pellets per square meter for 2 days, the outdoor pond was filled with water 1 meter deep and the indoor pond water was filled with 0.6-0.8 meters deep.

Second, mud loach stocking. The loach in the pool can be filled at a time or it can be delivered with it. The outdoor pond is stocked with 3 to 5 kg of mud per square meter, and the indoor pond is stocked with 5 to 10 kg of mud per square meter.

Third, daily management. The outdoor ponds should always clean the snow and dust on the ice surface. If the pond leaks, it should also be filled with water. The indoor pond can keep the water surface free of ice or thin ice. The new water should be replaced once every half month. The amount of water changed every time is 1/3 of the total water volume, and the water depth of the pool water is kept at 0.6-0.8 meters.

Engine Piston Parts

The piston is one of the main moving parts of the engine, is composed of combustion chamber components.
The pressure of the gas piston through the connecting rod to the crankshaft, realize the change from heat energy to mechanical energy.
The work condition is very bad, and the temperature of 1400-1800 DEG C, and pressure
Up to 13MPa above the gas contact, greatly alternating thermal stress and mechanical stress.
And by the serious corrosion of gas, and under the condition of boundary lubrication and cylinder wall friction and strong impact 1 times.
The piston in high temperature, high pressure, strong corrosive gas contact so that it has enough strength and hardness,
Heat resistance and good thermal resistance, high fatigue strength and corrosion resistance. For high speed diesel Engine Piston also requires light as far as possible.
In order to reduce the inertia force.
Marine piston large low speed diesel engine of the crosshead is usually combined.
The heat treatment process by normalizing and annealing, and iron pearlite are ferrite organization, has good heat resistance.
Piston alloy quenched and tempered steel has better heat resistance and corrosion resistance. The skirt with nodular cast iron annealing treatment, with good wear resistance.

Engine Piston Parts,Engine Parts ,Car Engine Parts,Parts Of Engine,Piston Engine Parts

ZhouShan HeCheng Machinery Co., LTD. , https://www.hcmarineparts.com