Precautions for using the hair removal machine

With the improvement of living standards, the slaughtering market now uses automatic hair removal after slaughtering. The hair removal machine can remove feathers, fine hairs, claws and epidermis dirt at one time, and can also be used for removing ginger, peeling potatoes, removing fish scales and other agricultural products. . However, while using the hair removal machine, you must pay attention to a few points to ensure safety and efficiency.

Method / step

1. Ensure power supply safety: Install the earth leakage switch on the grounding wire; plug in the power supply before use, and turn on the switch to check whether the turntable is working properly.

2. Animal slaughter: When the animal is slaughtered, the knife edge is as small as possible. After slaughter, it is recommended to first pour the pig, cattle and sheep in warm water (about 60 degrees), and then put some salt in the warm water to avoid the mane. The epidermis is damaged.

3. Machine work: After the machine is started, it is necessary to add water to the animals while running. The Zui is hot water of 65°C-80°C; the hair removal time of various livestock should be mastered, and it should not be off or unreleased. phenomenon.

4. Timely cleaning: After removing the hair, apply the water to rinse the hair removal barrel, but it can't be directly washed with the spray pipe and treated in time to avoid harm to the environment or harm to human health; water can be recycled, but it should be timely when not in use. deal with.

5. Take the safety of the object: When the animal or other object that needs to be depilated is finished, it is necessary to take out the hair removal machine and then take it out to ensure the safety of the user.

6. Maintenance and maintenance: The hair removal machine pays attention to maintenance and maintenance in normal use. If it is properly maintained and maintained, it can greatly prolong its service life and save you a lot of money. For example, if you frequently check the turntable, if you find that the rotation speed of the turntable is slow, the belt shaft may slip. You should tighten the nut of the machine base, and pay attention to it should not be too tight; for example, check the rubber wool stick frequently, because the long-lasting rubber wool stick is easy. Wear or break, should be replaced in time to ensure normal hair removal efficiency.