Feeding procedures are based on the amount of material before the first egg is laid and the peak amount of egg production, and then based on the weight, growth status, evenness, feeding time, egg production rate, egg weight, and growth of the chicken. Trends, ambient temperatures, feed energy levels, and projected peak loads were developed. A "multiple small amount" method was gradually added to the peak amount to maintain the orderly ovulation of the hens of the breeding hens. When egg weight, egg production rate and body weight are insufficient or exceed the standard, feed time should be advanced or postponed. In actual production, attention should be paid to observing the weight, material quantity, feeding time, total egg production, chicken house temperature, etc., and timely adjust the frequency and extent of feeding. 2. Formulate the feeding mode for each batch of breeding chickens. The best feeding management procedures should be established according to the growth status, production performance, environmental conditions, and equipment conditions of each batch of breeding chickens. 3. When the egg production rate is between 5% and 10% according to the egg production rate, the egg production rate will increase according to the growth rate. It is expected that when the peak egg production exceeds the performance standard for laying eggs, the amount of feed should be further increased after the egg production rate reaches 70%. The increase in feed production rate is conducive to the rational use of feed nutrients, which enables the breeder to establish a nutritional balance between egg production and body weight, so that the breeder can maintain a good egg production condition, and the rate of death is low, and can be sufficient. Play the breeder's egg production potential. For example, if a chicken has an egg production rate of 5% at the end of the 25th and the basic material is 130g, the predicted peak load is 170g. When the egg production rate reaches 70% and the peak material quantity is reached, the egg production rate increases by 1% and 0.6g. .
Excretion is an important part of metabolism, however, due to various reasons, many patients will not be able to auto- urinate normally and smoothly. So we need to help urinate manually. Catheterization is a very common practice of nursing operations after closely observed and documented.
You will find all of the disposable urinary care products in this category.
Disposable Urethral Catheter,Red Latex Catheter,Red Latex Urethral Catheter,Curving End Foley Catheter,Foley Urine Catheter,Disposbale Ostomy Bag,Urine Collection Bag,Urine Cup NINGBO YINGMED MEDICAL INSTRUMENTS CO.,LTD , https://www.chinayingmed.com
1. Determine the degree of evenness and fullness of chickens in the feeding programme at 20 weeks, and determine the amount of feed before the start of production. If the coefficient of variation of the flock is less than 10%, the first feed should be started when the egg production rate reaches 5%; the coefficient of variation is greater than 10% and should be added when the egg production rate reaches 10%. The increase in the amount of material should be determined exactly according to the actual egg production and egg weight level of the flock.
Yingmed offers you a series of catheter-related care products. For example: Silicone catheter, Urine bag, Urinal,Bed Pan .
Through the urine and stool, doctors can judge patients` condition. Yingmed also provided Urinal cups and disposable tubes for storage , then the urine and stool could be delivered to lab to do analysis. In addition, the urine analyzer will help the experimenter to get a correct data .