"Jinniu Brand" series rakes, crushers, large silos Sodium Nitrite,Inorganic Acid,Nitrit Salt Polyurethane Catalyst,Rubber Auxiliary Co., Ltd. , http://www.wflonggang.com
1.Before starting the machine, you must read the instruction manual carefully, and adjust and maintain it in accordance with its provisions. Check whether the fasteners are tightly tightened. Whether the knife turning direction is the same as the specified direction. Whether the upper hood is locked, the machine leg, chassis, knife Whether the plate has cracks, etc., find problems in a timely manner.
2. The work site of the rake should be spacious and equipped with fire prevention equipment.
3, actually according to the provisions of the squeegee machine signs selected matching motor, not allowed to increase the number of spindle rotation, not allowed to remove the protection of the various parts.
4. When replacing the fastening screws of the movable and fixed blades, high-strength type 8.8 fasteners must be used instead of ordinary firmware.
5. No metal, stone or other hard objects shall be mixed in the material to be cut.
6. Before starting the machine, check whether the mask switch is too tight so as to avoid opening the hood when it is working. This will cause accidents. The protective cover must be installed properly and cannot be removed.
7. Young people under the age of 16 should not work alone. Those who do not master the rules of using the rakes are not allowed to work alone.
8. It is forbidden for the operator to start the machine after drinking, illness or excessive fatigue. During operation, it is forbidden to stand in the direction of rotation of the cutterhead, and it is forbidden to step on the material at the feeding entrance or reach out to the upper and lower grass rails to touch or advance the material. It is forbidden to use a wooden rod or a metal rod to push materials into the straw roller. Work to ensure human safety.
9, to ensure that the above conditions before the electrical wiring (reverse operation is strictly prohibited), no load 3-5 minutes, no abnormal phenomenon can be fed feed cutting operation.
10. During the operation, if abnormal sound response is detected and the machine is shut down immediately, it is forbidden to troubleshoot and open the protective cover when the machine is running.
11. When weeding grass, properly adjust the amount of material to be fed, too much can easily cause overload and stall, and too little affect the efficiency of weeds.
12. When feeding materials, both hands are strictly prohibited near the roller, so as not to bring the material into the machine and cause personal injury accidents.
13. It is forbidden to shift gears during operation. For short grass, turn the spindle wheel by hand and move the shift handle to the “short†position. If you have long grass, turn the spindle wheel by hand and move the shift handle to the "long" position.
14, safety shield. The factory is set by motor. The diesel engine uses transmission output protection to solve it on its own.
If you have any objections please call the contact: Chen Guangnan Mobile