The most notable feature of the immersion type steam-water mixer is that the heating is stable, silent, and vibration-free. In order to avoid the phenomenon of noise, vibration, and heating instability when the heater is used, what problems should be paid attention to in the installation of the equipment? The first submerged soda mixer means that the soda mixer must be sunk in the water, it should be installed in the middle of the container; 2 to ensure that the water submerged mixer is more than 100mm, about 200mm from the bottom; 3 the steam pipe introduced into the container should be fixed There should be no looseness; 4 Install a check valve on the steam pipe near the water source side to prevent water from flowing back into the steam zone and impact the pipe system to generate vibration. When multiple units are used in parallel, they should be evenly arranged. 
From the working principle of the submerged steam-water mixer, the steam is sprayed into the casing from the joint at a high speed, which generates a strong ejector effect on the surrounding cold water. The cold water enters the steam-water mixer through the inclined hole on the outer wall and exchanges heat with the steam at high speed. ; perform full heat exchange. The size of the inclined hole affects a heat exchange surface of steam and water. When using it, it must ensure that the inclined hole has no blockage. Therefore, it is necessary to ensure that no impurities in the pipe are brought into the steam-water mixer. It is a good choice to install the filter. There is very little chance that the heater will generate noise during operation. Usually, the steam pressure is too high, so that the steam and water are not mixed and exchanged between the core and the casing of the heater, but outside the heater, so only the adjustable The steam pressure valve can be adjusted to reduce the steam pressure.