First, run in place long life. Some owners and drivers mistakenly believe that running-in trials are an extra step. Therefore, buying a new car or overhauling a locomotive is not without running-in, or it will take a few laps and go hastily. As a result, the wear of the locomotives is accelerated, the faults are increased, the benefits are reduced, and even the cast suffers. Second, small lubrication and wear on time. The lubrication of various parts of the locomotive should be carried out on time and in accordance with the location. Do not ignore some lubrication points that do not immediately show a fault, otherwise, a long time will lead to major problems. For example, the phenomenon that the lubrication parts such as the oil pan and the air filter cannot be timely or filled with oil, causing serious mechanical accidents. Third, the correct operation of protective machine parts. Some drivers like to use the force when operating the shift lever, for fear of hanging on the block, resulting in damage to the mechanism, resulting in an accident; or brake force is too large, too fast, easy to damage the mechanism or brake failure; or clutch pedal did not Stepping to the end, the separation is not completely easy to break the gear; or when the brakes do not first close the throttle; or brake by hand when the emergency brake is used. All these things should be carefully corrected. Fourth, eliminate "three leaks" and fewer failures. Three leakage (leakage, leakage, leakage) phenomenon, not only affect the appearance of the locomotive, but also a great harm, from the waste of oil, power, wear, speed, increased failure; weight is caused by mechanical and personal accidents. To underestimate the "three leaks" is also a big mistake for drivers. Fifth, there are many benefits from the initiation of civilization. When the locomotive starts, it is necessary to shake the car. The method of using only the car in the winter, pulling (pushing) the car, sliding the slope, adding the fuel to the intake pipe, or using the open flame in the winter is not correct.
Pain Relief Patch
Pain Relief Patch(Pain Areas) Pain Relief Patch(Pain Areas),Shouler Pain Relief Patch,Joints Pain Relief Patch, Muscle Pain Relief Patch Shandong XiJieYiTong International Trade Co.,Ltd. , https://www.xjplaster.com
[Name] Medical Cold Patch
[Package Dimension] 6cm×8cm 4pieces/box
The pain relief patch is composed of three layers, namely, backing lining, middle gel and protective film. It is free from pharmacological, immunological or metabolic ingredients.
[Scope of Application]
For cold physiotherapy, closed soft tissue only.
[Indications]
The patches give fast acting pain relief for strains, sprains, cramp, bruises, swollen areas or joint stiffness.
[How To Use a Patch]
Please follow the Schematic Diagram. One piece, one time.
The curing effect of each piece can last for 6-8 hours.
[Attention]
Do not apply the patch on the problematic skin, such as wounds, eczema, dermatitis,or in the eyes. People allergic to herbs and the pregnant are advised not to use the medication. If swelling or irritation occurs, please stop using and if any of these effects persist or worsen.notify your doctor or pharmacist promptly. Children using the patch must be supervised by adults.
[Storage Conditions]
Store below 30c in a dry place away from heat and direct sunlight.