Combine harvesters are large-scale agricultural machines with a complex structure and large investment. They use a short time each year and have a long storage period. Therefore, after the completion of the operation, it is necessary to conduct timely maintenance of the storage so that it can maintain a good technical state to prolong its service life. 1. Rotate the engine crankshaft once a month and inject a small amount of clean oil into the cylinder; distribute the valve operating handle back and forth several times before and after the operation. 2. Open the water tank, body, and oil cooler drain switch of the engine, and put the cooling water: discharge the oil in the fuel tank and the oil in the oil pan; use the plastic cloth to put the air filter, exhaust nozzle, fuel tank The filling port and other parts are wrapped; an appropriate amount of clean oil is injected into the cylinder, and the plate is rotated several times by the crankshaft. 3, the main electrical components such as generators, lighting headlights, remove and wipe clean, save it separately to avoid damage. 4. Remove the battery and store it separately. Preservation method: After the battery is fully charged, pour out the electrolyte, change into distilled water, park for 6 hours, recharge for 4 hours, replace distilled water, recharge for 2 hours, then pour distilled water, and then fill with fresh distilled water. Store. 5. Combine the combine harvester with square wood to lift the front and rear tires off the ground; lower the harvesting table and pull-out wheel to the lowest position, and place it on the wood stably, so that the hydraulic system does not bear the load. 6. Add grease to each rotating bearing; apply friction or oil to the friction parts, such as cutters, clutch claws, auger extension claws, adjustment bolts, etc., to prevent corrosion; paint has worn away rusted parts and should be Derusting and repainting. 7. Completely inspect the consumables on the machine, such as auger telescopic rod sets, moving blades, friction plates, roller spikes, fixed nails, etc. If excessive wear, deformation, or damage is found, it should be repaired or replaced. 8, remove all the triangle tape, wipe clean and coated with talcum powder, tied the label, hang on the wall inside the library; remove the chain into diesel clean, coated with oil or butter, wrapped in kraft paper, put Ventilated and dry place. 9. Clean the dirt, stalks, grains and other impurities inside and outside the machine, rinse them with water, dry them, and store them in the storage room. The non-invasive/high-flow integrated ventilator (BPAP-HE) is a non-invasive ventilator, a high-flow respiratory humidifier, or a high-performance humidifier. BPAP HE,Non Invasive Vent,Niv Breathing Machine,Non Invasive Ventilation Machine Shenyang RMS MEDICAL TECH CO.,LTD , https://www.medicalrms.com
The non-invasive ventilator mode of this product can be used for adult patients who do not rely on invasive ventilation support, such as respiratory dysfunction, to provide ventilation assistance and respiratory support;
Products with high-flow heating and humidification mode can be used for humidification and oxygen therapy for adult patients with spontaneous breathing.